Filter
Top Products
Heatilator • ADI60S • 345-900 Rev. G • 9/08
22
Log Set Assembly: LOGS-ADI60
F. Positioning the Logs
CAUTION: Logs are fragile! Carefully remove
the logs from the packaging.
If the gas logs have been factory installed they should not need to be positioned. If the logs have been packaged separately,
refer to the following instructions.
1
1
2
2
5
5
4
4
3
3
6
6
7
7
345-935 6/02
LOG #1 (SRV340-701): Place log #1 in the back on the insert. Locate the legs of the log outside the 3/8”
tabs to either side of the burner. Pull the log forward until the log is stopped by the back edge of the burner. The
log should be centered.
PILOT
BURNER
BASE PAN
LOG #2 (SRV340-702): Position log #2 by locating its slot over the tab on the front left of the burner. The
slot in the left end of the log slides into the vertical metal edge in front of the square cut out on the base pan.
2
2
2
2
1
1
1
1