Filter
Top Products
Replacement
Motion Sensor
Requirements
• The light control requires 120-volts AC.
• If you want to use Manual Mode, the control must
be wired through a switch.
• Some codes require installation by a qualifi ed
electrician.
© 2007 HeathCo LLC 598-1155-01
Features
• Turns on lighting when motion is detected.
• Automatically turns lighting off.
• Photocell keeps the lighting off during daylight
hours.
• LED indicates motion was sensed (day or
night).
Model SH-5407
OPERATION
Move ON-TIME Switch
to 1, 5, or 10 minutes
Mode Switching Summary
Flip switch off for
one second then
back on*
* resets to Auto Mode at dawn.
TEST
AUTO
MANUAL MODE
ON-TIME
ON-TIME
* If you get confused while switching modes, turn the
power off for one minute, then back on. After the
calibration time (1
1
/
2
min.) the control will be in the
AUTO mode.
10 5 1 TEST
10 5 1 TEST
MANUAL MODE
AUTO
TEST
... back on.
1 Second OFF
then...
Manual mode only works at night
because daylight returns the sen-
sor to AUTO.
Flip the light switch off for one
second then back on to toggle
between AUTO and MANUAL
MODE.
Manual mode works only with
the ON-TIME switch in the 1, 5,
or 10 position.
Note: When fi rst turned on wait about 1
1
/
2
minutes
for the circuitry to calibrate.
Put the ON-TIME switch in the 1,
5, or 10 minute position.
Put the ON-TIME switch on the
bottom of the sensor in the TEST
position.
Mode: On-Time: Works: Day Night
Test
5 Sec x x
Normal
1, 5, 10 min. x
Manual
Until Dawn* x