Filter
Top Products
2
598-1338-01
WIRING
One Motion Light
Two Motion Lights
Recommended Grounding Method
Use a green ground “pigtail” (not provided) and
twist one end together with the bare fixture wire
and the box ground wire. Secure with a wire con-
nector. Secure the other end of the “pigtail” with
the GND screw on the X-bar.
CAUTION: DO NOT connect the RED wire
unless you want to control other lights from
the motion sensor (see Optional Wiring).
Black to black
White to white
Note: All wiring should be run in accordance with the
National Electrical Code through conduit or another
acceptable means. Contact a qualified electrician
if there is any question as to the suitability of
the system.
WARNING: Turn power off at circuit breaker
or fuse.
If you have metal junction box, you may not need the
green “pigtail”. If you are unsure about the grounding
method, consult your local building code.
Connect the fixture wires to the wires in the junction
box. Twist the wires together and secure with wire
connectors.
Black
White
Green or
Bare
Light
Fixture
Black
White
Green or
Bare
Light
Fixture
Light
Fixture