Filter
Top Products
-4-
595-5506-11
Battery
Battery
Battery
C
h
i
m
e
V
o
l
u
m
e
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
* Code Settings 1-7
Must Match Both
Push Button and
Chime
Inside Push
Button
Inside Chime
Note: Some models might require the use of
tweezers to remove and replace the jumpers.
Tune Setting
Tune Setting
(Not used on
all models)
Tune Settings
Your Heath
®
/Zenith wireless chime has different selectable tunes: Ding (one
note), Ding-Dong (two note), or Westminster (eight note) (Available on se-
lected Heath
®
/Zenith chimes). The factory setting is for the Ding-Dong tune
(or Westminster, when available). This tune can be changed by following the
instructions below.
• Ding (one note tune)
Push Button: Add a jumper to location 8.
• Ding-Dong (two note tune)
Push Button: Remove jumper from location 8.
Chime: Remove jumper from location 8.
• Westminster (Eight note tune) (Available on selected Heath
®
/Zenith
chimes)
Push Button: Remove jumper from location 8.
Chime: Add a jumper to location 8.
Note: All models have both front and back door tune capabilities. You may
purchase any Heath
®
/Zenith wireless push button for a second entrance. We
recommend the back door use the Ding tune and the front door use the Ding-
Dong tune (or Westminster tune, available on selected Heath
®
/Zenith chimes).
Models that include two push buttons will come factory set for front and back
doors. Decals on the rear of the push button will indicate its setting.
Push Button Battery Replacement
Install an alkaline type A23 12 Volt battery.
See diagram inside push button for correct
battery orientation.