Heath Zenith 6180 Door User Manual


 
-3-
595-5506-09
Code and Tune Settings
Code Settings
Note: Most installations will not require you to change any jumpers on
your chime and push button.
The push button and chime communicate by using a code that can be changed
by removing and/or adding jumpers on both the push button and chime. The
code is factory set; however, there are 128 selectable codes that allow you
to expand your system and prevent outside interference. Other wireless prod-
ucts may cause interference and the system may not function properly. Fol-
low the instructions below for setting a new code.
1. Open the cases and locate the jumpers on both the push button and chime
(See illustration on page 4).
2. The push button and chime both have eight different jumper locations.
The jumper positions 1 through 7 are used for setting the code.
3. To change the code, add and/or remove jumpers as needed. It is recom-
mended to only change one jumper at a time and then check to see if
system is functioning properly. Note: Jumpers in positions 1 through 7
must be exactly the same for both the push button and chime for this
system to function.
Clock Chimes
Battery Installation and Setting Time
Note: This feature is only available on specific models.
1. Install battery into clock. Firmly grasp brass
ring and carefully pull forward to remove clock
assembly from front of chime. Gently pull off bat-
tery cover located on back of clock assembly. In-
stall "AA" battery according to polarity marks in-
side battery chamber. Replace battery cover.
2. Set time. With battery cover removed, turn
time setting dial on back of clock assembly until
time is correct. Replace battery cover. Replace
clock assembly into chime face by pressing as-
sembly gently into hole on chime face.
3. Install batteries into chime. Remove clock
chime back. Grasp cutouts on back of chime with fingers. Gently push back up
and pull lower part of back out to remove. Install 3 alkaline "D" batteries ac-
cording to polarity marks inside battery chamber. Replace back of chime by
following the above instructions in reverse (see illustration on page 1).
Time Setting
Dial
Battery
Cover