Heath Zenith 6153/62/71/72 Door User Manual


  Open as PDF
of 24
 
-2-
595-5611-07
6. Mount push button.Useeitherscrewsordouble
sidedtapetomountpushbutton.
• ScrewMounting:Tomountwithscrews,remove
backofcasebypushingintabonbottomwithasmall
screwdriver(seeFigure1).Note: Remove material in
screwholes(ifneeded)beforemountingwithscrews.
Attachbackofcasetodoorjamborwall(seeFigure
4).Snapfrontofpushbuttonon.
• Tape Mounting:Whenattachingpushbuttonusing
double sided tape, make sure the surface of the door
jamborwallisclean.
7. Mountchime. Chime can be mounted by using 3
holesinthebackofcase,orbyusing2screwswith
keyholes.
KeyholeMounting:Determinemountinglocation.
• Marktwoholelocations.Note:Makesureholesarelevelbeforedrilling.
• Models6153and6162
(see Figure 5)
:3-5/16"(8.4cm)apart.
• Models6171and6172
(see Figure 5)
:2-3/8"(6cm)apart.
• Drilltwo7/32"diameterpilotholesforwallanchorsandinsertanchors.
• Mountkeyholescrewstowallleavingabout1/8"(3mm)ofthescrewthreads
exposed.
•
Snapcoverontochimebase.
• Models6153and6162:Aligntopedgeofcasewithtopofbackplate.Rotate
bottomofcasetowardbackplateandsnapintoposition(seeFigure7).
• Models6171and6172:
Alignbottomedgeofcasewithbottomofback
plate.Rotatetopofcasetowardbackplateandsnapintoposition
(see
Figure7).
•
Usingkeyholesonbackofchimebase,hangbaseonscrews(seeFigure5).
ScrewMounting:Determinemountinglocation.
• Placechimeagainstwallandverifythechimeislevel.
• Usechimeholesasatemplate(seeFigure6).Drillthree7/32"diameterpilot
holesforwallanchors(provided)andinsertanchors.
• Insert3screws(provided)throughholesinbackofchime.
• Verifychimeislevelandtightenscrewssecurely.
•
Snapcoverontochimebase.
• Models6153and6162:Aligntopedgeofcasewithtopofbackplate.Rotate
bottomofcasetowardbackplateandsnapintoposition(seeFigure7).
• Models6171and6172:
Alignbottomedgeofcasewithbottomofback
plate.Rotatetopofcasetowardbackplateandsnapintoposition
(see
Figure7).
Figure 4
 previous next