Heath Zenith 6153/62/71/72 Door User Manual


  Open as PDF
of 24
 
© 2008 HeathCo LLC 595-5611-07
This package includes (Style of push button and chime may vary from illustration):
• Wirelesschime
• Wirelesspushbutton(model6162includes2)withbattery
• Hardwarepack
This chime requires 3 “D” alkaline batteries (not included). In typical use,
alkalinebatterieswilllastuptothreeyears.
Wireless Chime
Figure 1
WARNING: To prevent possible
SERIOUS INJURY or DEATH:
• NEVER allow small children near
batteries.
• Ifbatteryisswallowed,immediately
notifydoctor.
1. InstallalkalinetypeA2312voltpushbutton
battery(included). Remove back of case by
pushingintabonbottomwithasmallscrew-
driver(seeFigure1).Seediagraminsidepush
buttonforcorrectbatteryorientation.Note: If
batteries are preinstalled, remove orange
batterytab.
2. Openchimecase. Press in catch on bottom of
chimeandliftthecaseopen(seeFigure2).
3. Install 3 alkaline “D” batteries. Make sure
batteriesareorientedproperly(seeFigure3).
4. Test range. Temporarily position chime and
pushbuttonwhereyouwantthemmounted.
Press push button to verify chime and push
buttonworkproperly.Ifchimedoesnotsound,
see Troubleshooting.
5. Adjust volume control. Adjust volume control
todesiredvolume(seeFigure3).
Type “D”
Type “D”
Type “D”
Chime
Volume
Figure 2
Figure 3
Models6153/62/71/72
next