Heath Zenith 6144 Door User Manual


  Open as PDF
of 24
 
-5-
598-1143-02
Removescrewto
open access door
BackofChime
4. To change the code, either:
• Addajumpertothesamelocationonboththepushbuttonandthechime
or...
• Removeajumperfromthesamelocationonboththepushbuttonandthe
chime or...
• Moveajumperonthepushbuttonfromonelocationtoanother.Movethe
correspondingjumperonthechimetomatchthenewlocationinthepush
button.
Example:Movejumperatlocation“5”tolocation“4”onboththepush
button and the chime.
Note: Code positions 1 through 7 must be exactly the same for both the
push button and chime for this system to function.
Note:Unitwillcomefactorysetwithjumpersinlocations5,6,and7onthe
push button and on the chime (see Figure 5).
Therangeofthewirelesschimecanvarywithlocation,temperature,and
battery condition.
* Code Settings 1-7
MustMatchBothPush
ButtonandChime
InsidePush
Button
Note: Some models might require the use of
tweezerstoremoveandreplacethejumpers.
Figure 5
12345678
VOLUME
1234567
 previous next