Filter
Top Products
7598-1306-02
ENGLISH
6. Set desired DIM level. Note: DIM setting remembers last
setting used. To recall last DIM setting from ON or OFF, push
and release either the top or bottom of DIM button.
Note: The DIM setting defaults to 50% in the event of a power
failure.
Bulb Replacement
Move the power disconnect switch to the OFF (left side) position.
Replace bulb(s).
CAUTION: Do not exceed the maximum load limits
listed above.
Operation
1. Verify the power disconnect switch is in the ON (right side)
position.
2. Push the ON (top) button and release. The light should turn on
full bright. Note: If you are controlling a lamp, make sure it is
connected to the switched outlet and the lamp is switched on.
3. Push the OFF (bottom) button and release. The light should
turn off.
4. Push either the top or bottom of DIM button and release. The
light should turn on at 50% brightness (or last setting).
5. Push and release top of DIM button to increase brightness.
Push and release bottom of DIM button to decrease bright-
ness. Note: There are 5 DIM settings ranging from 15% to 90%
brightness.