Heath Zenith 598-1143-01 Door User Manual


 
-4-
598-1143-01
Troubleshooting
Chime does not sound and strobe does not flash:
Make sure push button and chime codes are the same (See pages 2 and 3).
Check orientation of push button battery (See page 3).
Check push button battery charge, replace if necessary.
Batteries seem OK, but the chime and strobe do not work when installed:
Do not mount chime or push button on metal or near metal studs. This
reduces the transmitter range. Use 1/4" to 1/2" (6 to 13 mm) wood shims to
move chime or push button off metal surface.
Concrete floors may reduce range. Move chime away from floor.
Try locating chime closer to push button.
The range of the wireless chime can vary with location, temperature and bat-
tery condition.
DANGER: Electric shock hazard. Do not open chime. No service-
able components inside. If strobe fails to flash, replace chime.
Regulatory Information
This device complies with Part 15 of the FCC Rules and RSS-210 of Industry
Canada. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
The user is cautioned that changes or modifications not expressly approved by
the party responsible for regulatory compliance could void the user’s authority
to operate the equipment.
Technical Service
Please call 1-800-858-8501 (English speaking only) for assistance
before returning product to store.
If you experience a problem, follow this guide. You may also want to visit our
Web site at: www.hzsupport.com. If the problem persists, call* for assistance
at 1-800-858-8501, 7:30 AM to 4:30 PM CST (M-F). You may also write* to:
HeathCo LLC
P.O. Box 90004, Bowling Green, KY 42102-9004
ATTN: Technical Service
* If contacting Technical Service, please have the following information available:
Model Number, Date of Purchase, and Place of Purchase.
No Service Parts Available for this Product