Filter
Top Products
-2-
595-5684-08
Code and Tune Settings
Code Settings
Note: Most installations will not require you to change any jumpers on
your chime and push button.
WARNING: Disconnect chime unit from power source before opening
code access door. Close door and replace screw before reconnecting
to power.
The push button and chime communicate by using a code that can be changed
by removing and/or adding jumpers on both the push button and chime. The
code is factory set; however, there are 128 selectable codes that allow you to
expand your system and prevent outside interference. Other wireless products
may cause interference and the system may not function properly. Follow the
instructions below for setting a new code.
1. Unplug wireless chime.
2. Open the cases and locate the jumpers on both the push button and chime
(See illustration on page 3).
3. The push button and chime both have eight different jumper locations. The
jumper positions 1 through 7 are used for setting the code.
4. To change the code, add and/or remove jumpers as needed. It is recom-
mended to only change one jumper at a time and then check to see if system
is functioning properly. Note: Jumpers in positions 1 through 7 must be exactly
the same for both the push button and chime for this system to function.
4. Mount push button.
Use either screws or double sided tape to mount push
button.
To mount with screws, remove back of case by pushing in
tab on bottom with a small screwdriver.
Attach back of case to door jamb or wall. Snap front of
push button on.
When attaching push button using double sided tape, make
sure the surface of the door jamb or wall is clean.