Heath Zenith 52-4042-2 Home Safety Product User Manual


 
4
598-1198-01
SYMPTOM
Lights will not come
on.
Lights come on
in daylight.
Lights come on
for no apparent
reason.
POSSIBLE CAUSE
1. Light switch is turned off.
2. Floodlight is loose or burned out.
3. Fuse is blown or circuit breaker
is turned off.
4. Daylight turn-off is in effect
(re-
check after dark).
5. Incorrect circuit wiring, if this is a
new installation.
6. Re-aim the sensor to cover de
-
sired area.
1. Light control may be installed in
a relatively dark location.
2. Light control is in TEST.
(Set
control switch to an ON-TIME
position).
1. Light control may be sensing
small animals or automobile traf-
fic (re-aim sensor).
2. Range is set too high.
(reduce
range).
SYMPTOM
Lights stay on
continuously.
Lights flash on
and off.
POSSIBLE CAUSE
1. A floodlight is positioned too close to
the sensor or pointed at nearby objects
that cause heat to trigger the sensor.
(Re-position the light away from the
sensor or nearby objects).
2. Light control is pointed toward a heat
source like an air vent, dryer vent, or
brightly-painted heat-reflective sur-
face. (Re-position sensor).
3. Light control is in manual mode.
(Switch
to Auto.)
1. Heat or light from the lights may be
turning the light control on and off.
(Re-position the lights away from the
sensor).
2. Heat being reflected from other objects
may be affecting the sensor. (Re-posi-
tion sensor).
3. Light control is in the TEST mode and
warming up. (Flashing is normal under
these conditions).
4. Light may be leaking through the flood
-
light reflectors. (Replace the lights with
new high quality PAR 38 lamps).
TROUBLESHOOTING GUIDE
If you experience a problem, follow this guide.
See your Canadian Tire retailer for warranty information.
No Service Parts Available for this Product