Filter
Top Products
4
The Beacon II™ Refrigeration System is a preassembled, factory installed refrigeration
system featuring an integrated microcomputer based electronic control board.
The Beacon II™ Refrigeration System replaces the expansion valve, solenoid valve, room
thermostat, defrost control and timer. It comes factory preset thereby eliminating all
of the expensive and time consuming ne tuning and adjustments necessary for a good system installation. For
additional information, contact your Sales Representative.
The Bohnmizer
®
System
The Bohnmizer® system is a complete factory furnished commercial refrigeration split system designed to operate
properly regardless of climatic conditions. As the ambient temperature falls below 75°F, the head pressure is
allowed to decrease in direct relationship to the ambient.
The heart of the system is the Bohnmizer valve, whose design allows the proper amount of refrigerant to ow to
the evaporator irrespective of the valve inlet pressure. The Bohnmizer valve also responds very rapidly to changes
in suction temperature, which assures the maintenance of low superheat, regardless of the ambient temperature.
The Bohnmizer system concept results in operational energy savings, increased compressor life, reduced
refrigerant costs and less maintenance expense.
™
Options
Electrical options: Outdoor Indoor Stock
Smart Defrost Kit™ Option Option N/A
Dual pressure control (not available on Beacon II™) Option Option N/A
Adjustable low pressure control for medium temp. comp. Option Option N/A
Crankcase heater Standard N/A Standard
Fused disconnect / Non-fused disconnect
Option Shipped loose N/A
Phase loss / low voltage monitor Option Option N/A
Fixed fan cycling — pressure or temperature (2 fan units)
(Pressure standard on Beacon II™)
Option Option N/A
Air or electric defrost timer only Option Option 1/2-3 HP low temp.
Electric defrost with timer & contactors (040-060 models only) Option Option 4-6 HP low temp.
Beacon II™ Option Option N/A
Mechanical options:
Head pressure control ooding valve Standard Option Standard
Liquid line drier, sight glass Option Option Standard
Suction line lter Option Option N/A
Suction accumulator (standard on X6 models) Option Option N/A
Oil separator with discharge line check valve (D cabinet) Option Option N/A
Liquid line solenoid valve and pumpdown switch Option Option N/A
Replaceable core liquid line lter (D cabinet) Option Option N/A
Replaceable core suction line lter (D cabinet) Option Option N/A
Precharged refrigerant with line sets and wire harnesses Option Option N/A
Oversize receiver (D cabinet) Option Option N/A
Low ambient kit with heated and insulated receiver, TD relay Option N/A N/A
12" Extended legs for snowbelt operation Shipped loose Shipped loose Shipped loose