Filter
Top Products
August 1, 2008
Page 37
Heat & Glo · Tiara Petite B · 7026-101K
KIT CONTENTS: (2) Warming shelves, (2) brackets, and (4)
1/4 in. Phillip head screws.
J. Warming Shelves Installation
TOOLS NEEDED: Phillips head screwdriver.
Figure 8.20
Remove warming shelves and hardware from
packaging.
Install leveling bolt to each warming shelf.
Figure 8.21
Install warming shelf bracket loosely to each
warming shelf using the bolt provided.
Figure 8.22 Gently lift cast top off of unit and set aside.
Install warming shelf to unit gently aligning the shelf with the
tabs that are in place on the side of the unit. Use the leveling
bolt in the located in the center of the warming shelf to adjust
the shelf to it's desired position.
Figure 8.23 Align bracket to fi rebox and gently tighten the
screw to hold it in place.
Reassemble the appliance.
K. Glass Replacement
Turn the appliance OFF and let it cool down before replacing
the glass. Lift off the appliance top and place it on a fl at
surface with the porcelain side up to prevent damage.
Remove the appliance front by sliding it upwards in the
grooves being careful not to chip the porcelain. Lay the front
face up on a fl at surface.
Unhook the latch now exposed on top of the appliance. Pull
the top of the glass frame toward you and lift it out of the
retainer along the bottom of the fi rebox.
Replacement is the reverse of the removal.
Handle glass assembly with care.
CAUTION
• Inspect the gasket to ensure it is undamaged.
• Inspect the glass for cracks, chips or
scratches.
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass door
removed, cracked, broken or scratched.
• Replace glass assembly as a complete
assembly.