Heat & Glo LifeStyle 8000TV-OAK-IPI Gas Heater User Manual


 
21Heat & Glo • 8000TV-OAK, 8000TV-OAK-IPI, 8000TVLP-OAKIPI • 2058-900 Rev. L • 08/08
This appliance MUST be used with a wall switch or a
remote control.
This unit is not for use with thermostats.
Keep wire lengths short as possible by removing any
excess wire length.
Low voltage and 110 VAC voltage cannot be shared
within the same wall box.
A. Recommendation for Wire
This appliance requires 110-120 VAC be wired to the
junction box either for use of optional accessories (stand-
ing pilot ignition) or for proper operation of the appliance
(Intelli re ignition). Refer to Figure 10.1 to determine if the
appliance uses an Intelli re ignition system or Standing
Pilot ignition system.
Open the control access panel to view wiring system and
gas valve. If this appliance has a red or black ignitor but-
ton (as noted in Figure 10.1) this appliance has a Stand-
ing Pilot ignition system. If there is no red or black ignitor
button, this appliance has an Intelli re ignition system.
10
10
Electrical Information
Note: This appliance must be electrically wired and grounded
in accordance with local codes or, in the absence of local
codes, with National Electric Code ANSI/NFPA 70-latest
edition or the Canadian Electric Code, CSA C221.1.
B. Connecting to the Appliance
Wire 110V to electrical junction box.
Do NOT wire 110V to valve.
Do NOT wire 110V to wall switch.
Incorrect wiring will damage millivolt valves.
Uninterrupted to continuous power is required
at all times in IPI system EXCEPT when using
battery back-up.
Incorrect wiring will override IPI safety lockout
and may cause explosion.
Figure 10.1 Standing Pilot Ignition
RED OR
BLACK
BUTTON
WARNING
Wall Switch
Position the wall switch in the desired position on the wall.
An assembly of 18 ft of 20 AWG is provided with the re-
place to connect the wall switch to the appliance. Instead
of the supplied assembly, wire with a length of 25 ft or less
and a gauge of 20 AWG through 14 AWG is acceptable.
The wire needs a jacket with a temperature rating of 140º
F (60º C) or higher. At the appliance connect the wire to
the ON/OFF switch pigtails.
A 110-120 VAC circuit for this product must be protected
with ground-fault circuit-interrupter protection, in
compliance with the applicable electrical codes, when
it is installed in locations such as in bathrooms or near
sinks.
Î