Filter
Top Products
Owner’s Manual Remote ContRolleR Heat Controller, Inc.
7
AUTO COOL DRY HEAT FAN
8
9
10
11
12
*
*
TEMP Button ▼: Push the TEMP button to decrease the indoor temperature setting or to adjust
the TIMER in a counter-clockwise direction.
MODE Select Button: Each time you push the button, a mode is selected in a sequence that
goes from AUTO, COOL, DRY, HEAT and FAN as the following gure indicates:
NOTE: HEAT feature only for heat pump models.
SWING Button: Press this button to change the louver angle which adjusts the UP/DOWN airow
direction.
ECONOMY Button: Press this button to go into the Energy Saving (Sleep) mode. When this func-
tion is operating, the set temp will increase (cooling) or decrease (in heating mode) by 2°F (1°C) per
hour for the next two hours, then remain constant for the next 5 hours. This new feature will remain
active for 7 hours before it returns to the originally selected temperature.
RESET Button: When the RESET button is pressed, all of the current settings are cancelled and
the control will return to the initial settings.
DIGITAL DISPLAY Button: Press this button to clear the digital display in the air conditioner.
Press it again to activate it.
TEMP Button ▲: Press this button to increase the indoor temperature settings or to adjust the
TIMER in a clockwise direction.
FAN Button: This button is used for setting Fan Speed in the sequence that goes from AUTO,
LOW, MED, to HIGH then back to Auto, as the following gure indicates:
ON/OFF Button: Press this button to start the operation of the unit. Press the button again to stop
the operation of the unit.
TIMER Button: This button is used to preset the timer ON (start to operate) and the timer OFF
(turn off operation).
CANCEL Button: Press this button to cancel the TIMER settings.
LOCK Button: Press this button to lock all the current settings and prevent settings from being
changed accidentally. To release settings, press again.
13
14
15
16
17
18
19
AUTO COOL DRY HEAT FAN
*
NOTE: HEAT feature only for heat pump models.