Filter
Top Products
Heat Controller, Inc. Room Air Heat Pump with R-410A Owner’s Manual
11
11
INS TALL THE AIR CONDITIONER
IN THE CASE
Slide the air
conditioner into
the case. Do not
push on the
controls or the
finned coils.
Make sure the
air conditioner
is firmly seated.
Reinstall the locking bracket and screw
removed earlier.
Reconnect the ground wire to the air
conditioner using the screw removed earlier.
IMPORTANT: The ground wire must be
reinstalled to ensure a proper ground.
Remove the front grille from its box and
remove the shipping tape.
Grasp the inlet grille at the bottom corners
and pull it forward. Unhook it from its top
hinges and set it aside.
Using the tab, p
ull up sl
ightly on the filter
to release it and pull it down and out.
F
E
D
C
B
A
8
Installation Instructions
INSTALL THE AIR CONDITIONER
IN THE CASE
(cont.)
Pull the coiled power cord from its shipped
position in the air discharge area. Attach
the front grille frame to the case by inserting
the tabs on the grille frame into the slots
on the front top of the case. Push the grille
frame in. And install the 2 type F screws at bottom
left and right side of front panel.
Secure the front grille frame to the case
with one type C screw.
Reinstall the filter.
Reinstall the inlet grille. Connect power.
J
I
H
G
8
Guide the lever carefully
through the grille frame
as you push it in.
INSTALL THE AIR CONDITIONER
IN THE CASE
IN THE CASE (cont.)