Filter
Top Products
Heat Controller Glass Panel Heater Owner’s Manual
5
OPERATION
• MODE BUTTON: There are four modes: LO, HI,
AUTO, and STANDBY. Press the MODE button
to scroll through the functions in the following
sequence:
• LO → HI → AUTO → STANDBY
LO: low-power heating.
HI: high-power heating.
AUTO: In the automatic mode, the desired
temperature can be set using the TEMP button.
When the ambient temperature reaches (or
exceeds) the set temperature, the heater will stop
heating. When the ambient temperature is below
the set temperature, the heater automatically
will switch to HI power to bring the ambient
temperature up to the set temperature.
STANDBY: The unit does not generate any heat
when in STANDBY mode. All settings are saved
while in STANDBY mode.
To exit the STANDBY mode, press the Mode button
until the desired mode is displayed.
• TEMP BUTTON: The temperature setting range is
41°F to 95°F (5°C to 35°C).To set the temperature,
press the TEMP button and the LED display will
show either the default temperature setting value of
75°F (24°C) or the last set temperature.
Press the TEMP button again to set the desired
temperature value. Once the desired temperature
is set, the display will show the set temperature for
5 seconds, then will display the current ambient
temperature.
POWER
SWITCH
CONTROL
PANEL
LED
DISPLAY
The power switch and control panel are located on
the right side of the heater enclosure.
The LED display shows in the upper right corner of
the glass panel on the front of the heater.