Filter
Top Products
1.5.2 COOLING AND HEATING MODEL
• OPERATION
—5—
A slight heat odor may come from the unit when
first switching to HEAT after the cooling season is
over. This odor, caused by fine dust particles on
the heater, will disappear quickly.
Turn the Temperature Knob to the desired setting. The central position is a normal
setting for average conditions. You can change this setting, if necessary, in
accordance with your temperature preference.
The thermostat automatically controls cooling or heating, but the fan runs
continuously whenever the air conditioner is in operation. If the room is too warm,
turn the thermostat control clockwise. If the room is too cool, turn the thermostat
control counterclockwise.
OFF - Turns the air conditioner off.
FAN ONLY - The low fan speed operation without cooling/heating.
LOW COOL - Cooling with the low speed fan operation.
HIGH COOL - Cooling with the high speed fan operation.
LOW HEAT - Heating with the low speed fan operation.
HIGH HEAT - Heating with the high speed fan operation.
When the air conditioner has been performed its cooling
or heating operation and is turned off or set to the fan
position, wait at least 3 minutes before resetting to the
cooling operation again.
CAUTION
• HEAT PUMP MODELS
When the outdoor temperature is lower than
-4°C (24°F), the electric heater will turn on instead of the
heat pump.