Filter
Top Products
—17—
3.3 PROCEDURE A
If you are using a new USC sleeve in conjunction
with your unit, skip to step 3. Otherwise, install the
plastic grille from the kit. Cut the plastic grille to fit
the rear opening of the existing sleeve. Place the
plastic grille to the inside of the wall sleeve at the
rear flange.
Fasten the 4 washer screws to secure the grille to
the wall sleeve. If you need plastic nuts to mount
plastic grille to the inside of the wall sleeve, there
are plastic nuts in the installation kit. The nuts are
installed from the inside of the sleeve and are
pressed into the square holes of the rear flanges.
Ensure that the inside of the sleeve is thoroughly
clean. Remove the backing from the Horizontal
Insulation strip 1
3
/
8
x
3
/
8
x 27
3
/
16
and attach that to
the inside bottom of the sleeve as shown below.
Remove the backing from the Around Insulation
strip 1
3
/
8
x
3
/
4
x 61
1
/
2
and attach that to the inside
front of the sleeve as shown below.
Install the new unit into the wall sleeve.
To assemble trim, snap the tab of each piece into
the slot of the other piece as shown below. Slide
trim over the front of the air conditioner until trim is
flush with sleeve as shown below.
FIG. 21
Around Insulation
Horizontal Insulation
FIG. 23
or
FIG. 22
1
2
3
4
5
Trim (2 ea)
Wall
FIG. 24
• Air conditioners covered in this manual pose
an excessive weight hazard. Two or more
people are needed to move and install the
unit.
To prevent injury or strain, use proper lifting
and carrying techniques when moving unit.
• When handling the air conditioner, be careful
to avoid cuts from sharp metal fins on front
and rear coils.
• Make sure air conditioner does not fall during
removal.
CAUTION