Filter
Top Products
2 4040-227 Rev B 12/05
REFRACTORY - CB & CD SERIES INSTALLATION INSTRUCTIONS
1. Shut off the electricity to the appliance and turn the gas shutoff
valve to the closed position. See Figure 1. Remove the screen
and glass from the appliance.
OFF
Figure 1 - Gas Shutoff Valve
Screws
Figure 2 - Loosen Grate
2. Lift the two top logs off the log set. See Figure 2.
3. Remove the grate/log assembly by removing the two screws
as shown in Figure 2. Lift and pull the grate/log assembly from
the front of the fi rebox.
Remove four screws securing the rear log. See Figure 3. Lift
rear log and remove from fi rebox.
Figure 3 - Remove Rear Log
4. Carefully install a side refractory. Tip the bottom edge into posi-
tion, and swing the top up. This will hold the back refractory in
place. See Figure 4.
Figure 4 - Tip Side Refractory
5. To secure the side refractory in place, remove the screw in
the fi rebox side. Attach a refractory bracket (using the screw
removed) to the fi rebox side. Leave screw loose until Step 7
to allow for adjusting. See Figure 5.
Figure 5 - Refractory Brackets