Filter
Top Products
Hearth & Home Technologies • RC300 Multifunction Remote Control • 2166-393 Rev. C • 9/10
3
Fan Installation
• Insert the 3 prong plug from the fan into the receptacle
located in the AUX300 module. See Figure 6.
• Insert 3 prong plug from AUX300 module into REM/AUX
receptacle of fi replace junction box.
Figure 6. Plug Fan into AUX300 Module
AUX 300 MODULE
AUX 300 MODULE
FAN CORD
FAN CORD
Figure 7. Programming RC300
REMOTE POSITION
REMOTE POSITION
Programming the RC300 to the Control Module
CAUTION! Risk of burns! DO NOT program the remote
control to the control module when fi replace is hot.
• Verify the ON/OFF/REMOTE switch is in the REMOTE
position. Green LED light will blink three times and wall
switch will beep once 5 seconds later when ready. See
Figure 7.
• Using a small item (such as a paper clip) press and
release the LEARN button located near the ON/OFF/
REMOTE switch. See Figure 7.
• Control module will beep once and LED will blink green
for 10 seconds.
• While the LED is blinking, press the POWER button on
the remote control. A double beep will come out of the
control module to indicate that it has been programmed
successfully.
NOTICE: Up to three remote controls can be programmed
into the control module. Simply press a button on the other
remote controls during the 10 second programming process
to add another remote into the system. It is recommended
to program only one RC300 remote control.
To clear memory in the control module, use a small item
(such as a paper clip) to press and release the LEARN
button. Control module will beep once and LED will blink
green for 10 seconds DO NOT press any buttons on the
remote during the ten seconds that the green LED blinks.
The memory will be cleared. Note that the RC300 will not
be programmed if it’s in STANDBY mode. Press the ON/
OFF button twice to switch to IDLE mode.