Filter
Top Products
Heatilator • Novus NDV Series • 4055-187 Rev F • 06/08 3
Safety Alert Key:
• DANGER! Indicates a hazardous situation which, if not avoided will result in death or serious injury.
• WARNING! Indicates a hazardous situation which, if not avoided could result in death or serious injury.
• CAUTION! Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
• NOTICE: Used to address practices not related to personal injury.
Table of Contents
A. Congratulations 2
B. Limited Lifetime Warranty 5
1 Listing and Code Approvals
A. Appliance Certifi cation 6
B. Tempered Glass Specifi cations 6
C. BTU Specifi cations 6
D. High Altitude Installations 6
E. Non-Combustible Materials Specifi cation 6
F. Combustible Materials Specifi cation 6
G. Requirements for the
Commonwealth of Massacusetts 7
User Guide
2 Operating Instructions
A. Gas Fireplace Safety 8
B. Your Fireplace 8
C. Fan Kit (optional) 9
D. Clear Space 9
E. Decorative Doors and Fronts 9
F. Fixed Glass Assembly 9
G. Remote Controls, Wall Controls and Wall Switches 9
H. Before Lighting Fireplace 9
I. Intermittent Pilot Ignition (IPI) 10
J. Standing Pilot Ignition 11
K. After Appliance is Lit 12
L. Frequently Asked Questions 12
3 Maintenance and Service
A. Maintenance Tasks-Homeowner 13
B. Maintenance Tasks-Service Technician 14
Installer Guide
4 Getting Started
A. Typical Appliance System 16
B. Design and Installation Considerations 17
C. Tools and Supplies Needed 17
D. Inspect Appliance and Components 17
5 Framing and Clearances
A. Select Appliance Location 18
B. Constructing the Appliance Chase 19
C. Clearances 19
D. Mantel and Wall Projections 20
6 Termination Locations
A. Vent Termination Minimum Clearances 21
7 Vent Information and Diagrams
A. Approved Pipe 23
B. Vent Table Key 23
C. Use of Elbows 23
D. Measuring Standards 23
E. Vent Diagrams 24
8 Vent Clearances and Framing
A. Pipe Clearances to Combustibles 33
B. Wall Penetration Framing 33
C. Install the Ceiling Firestop 34
D. Install Attic Insulation Shield 35
9 Appliance Preparation
A. Top Vent 36
B. Rear Vent 37
C. Secure and Level the Appliance 38
10 Installing Vent Pipe
A. Assemble Vent Sections (DVP only) 39
B. Assemble Vent Sections (SLP Pipe Only) 40
C. Assemble MI Sections (DVP only) 40
D. Assemble Slip Sections 41
E. Secure the Vent Sections 42
F. Disassemble Vent Sections 42
G. Install Decorative Ceiling Components (SLP only) 43
H. Install Metal Roof Flashing 44
I. Install RF4-8 45
J. Install Vertical Termination Cap 46
K. Assemble and Install Storm Collar 46
L. Install Heat Shields and
Horizontal Termination Cap 47
11 Gas Information
A. Fuel Conversion 49
B. Gas Pressure 49
C. Gas Connection 49
D. High Altitude Installations 49
12 Electrical Information
A. Wiring Requirements 50
B. Standing Pilot Ignition System Wiring 50
C. Intellifi re Ignition System Wiring 50
D. Optional Accessories Requirements 50
E. Electrical Service and Repair 51
F. Junction Box Installation 52
G. Wall Switch Installation for Fan (Optional) 52
13 Finishing
A. Mantel and Wall Projections 53
B. Facing Material 54