Filter
Top Products
Heat & Glo • FB-ZC-S • 2019-910 Rev. G • 11/08 25
Figure 11.2 Glass Assembly
F. Glass Assembly
Removing Glass Assembly
There are two glass latches on the left side of glass as-
sembly and two glass latches on the right side.
• To release glass assembly, pull latch forward and allow
to retract away from glass assembly.
• Remove glass assembly after all four latches have been
released (see Figure 11.2).
Replacing Glass Assembly
Replace the glass door on the appliance. Fasten the latches
on the glass frame.
GLASS LATCH
GLASS
ASSEMBLY
PULL TO
RELEASE
(LEFT SIDE
G. Air Shutter Setting
Optimal fl ame appearance is dependent on the air shutter
setting. Adjustments should be made by a qualified
technician.
Handle glass doors with care.
• Inspect the gasket to ensure it is undamaged.
• Inspect the glass for cracks, chips or scratches.
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass door removed,
cracked, broken or scratched.
• Replace glass door assembly as a complete appliance.
WARNING
NG LP
Burner 3/8 Full Open
LOG #6 (SRV571-707): Place log #6 across log #1 and log #3 in the grooved out areas as shown.
LOG #5 (SRV740-707): Place log #5 across the fl at on log #3 such that the ends of the log contact the grate
and log #2 as shown.
5
5
5
5
6
6
6
6