Filter
Top Products
Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08 21
7
7
Appliance Preparation
A. Removing Non-combustible Facing Mate-
rial Assembly
The non-combustible assembly is located on the back of
appliance (see Figure 7.1).
Figure 7.1 Non-Combustible Facing Material Assembly
• Hold non-combustible pieces in place.
• Remove and save two screws from upper brackets (see
Figure 7.1).
• Remove non-combustible pieces.
• Remove and save three screws from lower bracket (see
Figure 7.1).
• Discard brackets.
• Replace screws in holes where these pieces were
attached to appliance.
Handle with care.
• Non-combustible material may be damaged if dropped.
CAUTION
Remove screws
from upper bracket.
Lower
Bracket