Filter
Top Products
Page 36
September 1, 2008
Quadra-Fire · Topaz · 7009-113G
See Vent Graph for Recommendations on page 11
before you begin your adjustment. If your installation falls
within the range of the gray shaded area of graph, it may be
necessary to make an adjustment to the vertical damper to
improve the flame appearance in your appliance.
Figure 8.34 The shutter is located on the underside of the
appliance, on the right side. To adjust the shutter, loosen
the wingnut..
Moving the shutter bolt to the right closes the shutter. Moving
the shutter bolt to the left, will open the shutter. Opening the
shutter causes flames to become shorter and blue. Closing
the shutter creates taller orange/yellow flames.
NOTE: Do not close so much as to cause a sooty flame.
Improper adjustment can cause sooting in the firebox and/or
on the outside of a house with a horizontal termination.
After adjustment, tighten wingnut to lock in place.
K. Damper Adjustment
Make adjustment:
Let appliance warm up before adjusting.
Loosen screw using a Phillips head screwdriver.
Pivot the vertical damper adjustor in 1/4 in. (6mm) incre-
ments while observing the flame activity.
Turning clockwise to open damper = less flame height and
more blue in flame color.
Turning counterclockwise to close damper = increased flame
height and more yellow in flame color.
Make adjustment until flame size and activity suits your per-
sonal preference, and then retighten screws on adjustment
control.
Figure 8.32 TOP VENT INSTALLATIONS:
Locate the damper adjustment on the intake plenum. Access
through the appliance front. Adjustor is centered at the top
of the appliance.
L. Shutter Adjustment
FOR TOP OR REAR VENT INSTALLATIONS
Figure 8.33 REAR VENT INSTALLATIONS:
The rear vent
damper is located in the back of the firebox behind the rear
brick panel. It is recommended to make adjustment prior to
installation.
Remove front/glass/ logs and brick if installed. Loosen screws
and slide up to suggested settings. Reinstall accordingly...
Tighten screws.
OPEN
CLOSE