Filter
Top Products
KK-K9-F14-K_INST_11-08
6
. Attach rear support plate to bottom of rear floor lip using ¼” x ¾” hex head bolts. (Photo 3)
. Attach top of K9 mounting legs to floor using ¼”
les in mounting feet.
. Housing final step:
• Center K9 housing so tunnels are even on
both sides.
4
5 x ¾” carriage bolts and serrated nuts. Holes in
floo will line up with ho
6. Loosely attach side tu
r
nnels to main housing using ¼” x ¾” and ¼” x ½” carriage bolts.
Note: Use ½”long bolts on double skin and ¾”long on triple skin.
7
• Mount rear housing support to vehicle using
¼ x 1 ½” hex head lag bolts.
• Tighten all loose bolts on tunnels and
legs.
Top Inner Screw
Cent
over. A ach to door with #10 x ½”
Note:
er door panels so edges do not hang
tt
stainless sheet metal screws.
Window guards have holes around
perimeter for permanent mounting.
These holes are not used with hinge style
window kits! They also come flat in
shipping.
The window guard must be pre-
bent so it fits tight against the
contour of the door window
frame. The aluminum guard can
easily be formed at wok bench.
Hold window guard with pre-assembled
hinge and upper bracket onto window frame.
x
r
ame
me
.
Make sure guard is centered on window.
Attach hinge to lower door panel with #10
½” stainless sheet metal screws. Mark uppe
aluminum bracket location on window fr
and remove from window guard. Attach
upper aluminum bracket onto window fra
with #10 x ½” flat head sheet
metal screws