Filter
Top Products
Form No. EBOOSTERM-0406
29
ACCESSORIES
Figure 21. Optional Stainless Steel Adjustable Legs
STAINLESS STEEL ADJUSTABLE LEGS
1. Carefully place unit on its side.
CAUTION
Do not lay unit on the side with the control panel
or damage to unit could occur.
2. Thread the adjustable legs into the existing leg
holes on the bottom of the unit. (See Figure 21.)
3. After all legs are secure, return the unit to the
upright position.
NOTE: If unit is not level, use an adjustable open-
end wrench to adjust the foot of each leg until unit is
level. Each leg is adjustable from 6" (152 mm) to 7"
(178 mm).
FLOOR MOUNTING HARDWARE
Stainless steel adjustable legs with deck mounting
flange are available for securing the booster heater
to the floor.
SHOCK ABSORBER
The shock absorber installed between the booster
and the commercial dishwasher prevents hydraulic
shock induced by rapidly operating valves. The
shock can cause damage to the equipment.
BLENDED PHOSPHATE WATER
TREATMENT SYSTEM
The Blended Phosphate Water Treatment System is
installed before the booster heater and reduces
mineral scale build-up by introducing a measured
amount of polyphosphate into the water.