Harbor Freight Tools Model 93819 Septic System User Manual


 
3. Use the right product for the job. There are certain applications for which this
product was designed. Do not use small tools, attachments, or equipment to do
the work of larger industrial tools, attachments, or equipment.
4. Maintain a safe environment. Keep the area well lit. Make sure there is ad-
equate surrounding space. Always keep the area free of obstructions, grease,
oil, trash, and other debris. Do not use an electrically powered product in areas
near flammable chemicals, dusts, and vapors.
5. WARNING! Risk of electrical shock. Always disconnect the Pump from
its power source before handling or making any adjustments to the tool.
Always wear non-skid rubber boots when water is on the floor and you
must unplug the Pump. Never allow the internal Motor to get wet. Make
sure the electrical power source is a separately fused, grounded, 3-wire
type GFCI (Ground Fault Circuit Interrupter) outlet. Do not remove the
ground prong on the Power Cord Plug. Do not use an extension
cord.
6. Do not pump hazardous materials. Do not pump explosive or flammable
materials such as fuel, oil, kerosene, gasoline, etc. Do not pump in close proxim-
ity to flammable or explosive materials. Do not pump fats, oils, salt or waste
water. This Pump is designed to move clean or dirty water only. Do not
pump water over 95 degrees Fahrenheit.
7. Make sure the discharge pipe (not included) is secured to a solid surface to
ensure the stability of the Pump.
8. Make sure to position the Pump on a flat, level, solid surface.
9. WARNING! Always arrange a “drip loop” in the Power Cord connecting
the Pump to a 120 volt, GFCI electrical outlet. A drip loop is that part of the
Power Cord below the level of the outlet to prevent water from traveling along the
Power Cord and coming in contact with the outlet. If the Power Plug or electrical
outlet
does
get wet, do not unplug the Power Cord. Disconnect the fuse or
circuit breaker that supplies power to the Pump. Then, unplug the Power Cord
and examine for presence of water in the outlet. (See Figure A.)
PUMP
OUTLET
PUMP
OUTLET
WATER DRIPS OFF CORD,
AWAY FROM OUTLET.
FIGURE A
SKU
93819 For technical questions, please call 1-800-444-3353 PAGE 5
93820