Filter
Top Products
SKU 98342 For technical questions, please call 1-800-444-3353. Page 5
Troubleshooting
Problem Possible Causes Possible Solutions
Pump runs, but
will not deliver any
water.
Filter and/or impeller clogged.1.
When starting, the pump water 2.
height (1/8”) falls below the
minimum water level.
Low line voltage.3.
Optional check valve stuck or 4.
installed backwards.
Remove lter. Clean out dirt and debris from 1.
lter and impeller. Then replace Filter.
There must be at least 1/8” deep water for the 2.
Pump to operate properly.
Consult with an electrician.3.
Remove and examine check valve.4.
Pump won’t start
or run.
Check power connections and 1.
circuits/fuses.
Water level too low.2.
Filter and/or impeller clogged.3.
Defective motor.4.
Consult with an electrician.1.
Allow water level to rise above 1/8”, or move 2.
Pump to a lower location.
Remove lter. Clean out dirt and debris from 3.
lter and impeller. Then replace lter.
Have a qualied service technician repair or 4.
replace.
Excessive noise or
vibration.
Worn bearings.1.
Debris in impeller.2.
Discharge garden hose 3.
restricted.
Have a qualied service technician repair or 1.
replace.
Remove lter. Clean impeller. Then replace 2.
lter.
Clean Pump and discharge garden hose.3.
Pump starts
and stops too
frequently.
Water temperature too high.1.
Back ow of water from 2.
discharge garden hose.
Do not exceed temperatures above 95° 1.
Fahrenheit.
Install or inspect optional check valve.2.
Follow all safety precautions whenever diagnosing or servicing the
tool. Disconnect power supply before service.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT
HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS
QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/
OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD
BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE
BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER
INSTALLATION OF REPLACEMENT PARTS THERETO.