Filter
Top Products
15. Always arrange a “drip loop” in the Power Cord connecting the Pump (9) to
a 120 volt, grounded, electrical outlet. A drip loop is that part of the Power
Cord below the level of the electrical outlet, or the connector if an
extension cord is used, to prevent water traveling along the Power Cord
and coming in contact with the outlet. If the Power Cord Plug or outlet
does get wet, do not unplug the Power Cord Plug. Disconnect the fuse or
circuit breaker that supplies power to the electrical outlet. Then, unplug
the Power Cord and examine for presence of water in the outlet.
(See Figure A.)
.
.
.
SKU 93442 For technical questions, please call 1-800-444-3353 PAGE 6
16. WARNING! People with pacemakers should consult their physician(s) be-
fore using this product. Operation of electrical equipment in close proximity to a
heart pacemaker could cause interference or failure of the pacemaker.
17. WARNING! The warnings and cautions discussed in this manual cannot
cover all possible conditions and situations that may occur. It must be understood
by the operator that common sense and caution are factors which cannot be built
into this product, but must be supplied by the operator.
SAVE THESE INSTRUCTIONS
DRIP LOOP
(WATER)
120 VOLT, GROUNDED,
ELECTRICAL OUTLET
POWER CORD
FIGURE A