Filter
Top Products
SKU 91614 For technical questions, please call 1-800-444-3353. Page 5
6. To light the Burner and Fuel Jet Assembly (7), place a lit match next to the Burner and Fuel
Jet Assembly (7). Slightly turn the Burner Control Knob (8).
7. Slightly turn the Burner Control Knob (8) counterclockwise for the Burner and Fuel Jet
Assembly that (7) you wish to light. Remove the match from the Burner and Fuel Jet
Assembly (7) once the flame is ignited.
Increasing and Decreasing Heat/Flame to Burner Assembly
1. Turning the Burner Control Knob (8) counterclockwise will increase the flow of gas to the
Burner Assembly and Fuel Jet (7).
This will increase the size of the flame.
2. Turning the Burner Control Knob (8) clockwise will decrease the flow of gas to the Burner
Assembly and Fuel Jet (7).
This will decrease the size of the flame.
3.
To completely turn off the propane gas flow, turn the Burner Control Knob (8) completely
clockwise.
4.
If the Fuel Jet (8) gets blocked, it will need to be serviced by a qualified technician before
further use. Only a qualified service technician should perform the following steps:
(a) Remove the Tube and Valve Adapter (4). (b) Disconnect the Burner and Fuel Jet
Assembly (7) from the Stove. (c) Clean it with a mild detergent. (d) Reconnect the Burner
and Fuel Jet Assembly (7). (e) Replace the Tube and Valve Adapter (4).
Storing the Two Burner Propane Stove for Travel
Before folding up your Propane Stove for travel, make certain that it has completely cooled
off after use.
a) Make certain that all knobs are in the OFF position and all nearby flames and
sources of ignition are extinguished. Remove the Tube and Valve Adapter (4) from
the propane gas canister.
b) Unscrew the Tube and Valve Adapter (4) from the Stove.
c) Slide the tabs on the Cover (1) out from each Side Shield (2).
d) Fold down each Side Shield (2), and fold down the Cover (1).
e) Flip the Latches (6) around to the top so that they hold the Cover closed.
Unpacking
When unpacking your Two Burner Propane Stove, check to make sure the following parts
are included. If any parts are missing or broken, please call HARBOR FREIGHT TOOLS at
1-800-444-3353.
Part # Description Quantity Part # Description Quantity
1 Cover 1 5 Fuel Inlet and Air Control 2
2 Side Shield 2 6 Latch 2
3 Grid 1 7 Burner and Fuel Jet Assembly 2
4 Tube and Valve Adapter 1 8 Burner Control Knob 2
Note: Some parts are listed and shown for illustration purposes only and are not available
individually as replacement parts.