Filter
Top Products
Page 4
SKU 03394
Operation
See Assembly Drawing on page 7.
1. Fit the Cover (#2) on top of the Canister (#3) so that the grooves or lips of the
Canister (#3) line up and correspond to the grooves on the edge of the Cover (#2).
See FIGURE 1.
Note: On the inside of the Cover (#2), underneath the Rubber Gasket (#5) is the Wire Cage
Filter.
Grooves on Canister (#3)
Grooves on Cover (#2)
Ring (#1)
Rubber Gasket (#5)
Flex Pipe (#4) intake
Vacuum Cleaner Hose (not included) intake
2. Fit the Ring (#1) onto both of lips of the Cover (#2) and Canister (#3).
3. Seal the cover by closing the ring lock and securing the locking clasp on the Ring (#1) as
shown in FIGURE 2.
FIGURE 2
Locking Clasp
FIGURE 1
REV 02/04