Filter
Top Products
SKU 1118 For technical questions, please call 1-800-444-3353 Page 4
11. Remove adjusting keys and wrenches. Check that keys and adjusting wrenches are removed from the tool or
machine work surface before plugging it in.
12. Avoid unintentional starting. Do not carry any air tool with your finger on the trigger, whether it is plugged in or not.
13. Stay alert. Watch what you are doing, use common sense. Do not operate any tool when you are tired.
14. Check for damaged parts. Before using any tool, any part that appears damaged should be carefully checked to
determine that it will operate properly and perform its intended function. Check for alignment and binding of moving
parts; any broken parts or mounting fixtures; and any other condition that may affect proper operation. Any part that is
damaged should be properly repaired or replaced by a qualified technician. Do not use any air tool if its switch does
not turn On and Off properly.
15. Replacement parts and accessories. When servicing, use only identical replacement parts. Use of any other parts
will void the warranty.
16. Do not operate air tools if under the influence of alcohol or drugs. Read warning labels if taking prescription
medicine to determine if your judgment or reflexes are impaired while taking drugs. If there is any doubt, do not
operate the tool.
17. Maintenance. For your safety, service and maintenance should be performed regularly by a qualified technician.
18. Before using any air tool, read and adhere to all instructions and safety warnings provided in the instruction manual
of the tool being used.
Warning: The brass components of this product contain lead, a chemical known to the State of California
to cause birth defects (or other reproductive harm). (California Health & Safety Code 25249.5 et seq.)
Warning: The warnings, cautions, and instructions discus until sed in this instruction manual cannot cover
all possible conditions and situations that may occur. It must be understood by the operator that common
sense and caution are factors which cannot be built into this product, but must be supplied by the opera-
tor.
Unpacking
When unpacking, check to make sure all parts are included. Refer to the photo below, and the Parts List and
Diagram located at the end of this manual. If any parts are missing or broken, please call Harbor Freight Tools at
the number on the cover of this manual.
Assembly
1. Next thread the Air Regulator (3B) onto the Nipple (1B). See Figure 2 below.
2. Thread in the Air Valve (5B) into the Air Regulator Assembly. See Figure 3.
1B
2B
Figure 2 Figure 3
2B
5B
3. Thread the Regulator Handle (1C) into the Air Regulator (3B) until tight. See Figure 4. When assembly is complete, it
should look like the photo in Figure 5 below.
Figure 4
Figure 5
2B
1C
Assembly Continued
3B
1B
3B