5
User Instructions
Turn the water on by raising the handle. Lower the handle to turn the water off. Pivot the
handle to the right for cooler water, to the left for warmer water.
When the faucet is turned on, the sprayhead is in the stream mode. Press the button on top
of the sprayhead to activate the spray mode. When the water is turned off, the sprayhead
will revert to the stream mode.
The spray channels on the handspray use the Rubit
TM
cleaning system. If mineral deposits
are noticed in the spray channels, turn the water on lightly and wipe the spray channels
with your thumb or with a cloth.
If the flow of water diminishes over time, remove and clean the filter, located at the end of
the handspray hose.
Turn off the water at the supply stops.
Close the drain or cover it with a cloth. Gently pry
off the screw cover. Put it aside in a safe place. Use
a 4mm hex wrench to loosen the handle screw (4
revolutions). Remove the handle and the decorative
flange underneath.
Remove the nut.
Remove the handle screw from the stem of the
cartridge.
Remove the high temperature limit stop.
Replace the high temperature limit stop so that
the pin is in the desired notch. The temperatures
marked on the diagram assume an incoming hot
water temperature of 140
o
F and an incoming cold
water temperature of 50
o
F and a water pressure of
45 psi. Your results will vary.
Set the High Temperature Limit Stop
(optional):
Replace the nut, nut cover, screw and handle.