Filter
Top Products
3
666
1
2
3
Installation
If the mounting surface is greater than 3/16”, leave
the spacer ring intact.
Place the mounting plate over the stud. Tighten the
collar so that it is snug against the bottom of the mount-
ing surface.
Install the supply hoses to the stops with the compres-
sion fittings, taking care not to twist the supply hoses.
Install the pop-up drain.
Re-set the high temperature limit stop.
Turn on the water and test all connections for leaks.
If the mounting surface is less than 3/16” thick, care-
fully trim the spacer ring so that it is even with the
bottom of the faucet.