Filter
Top Products
3
Installation
Push the spout into place on the faucet. Tighten
the spout set screw.
Install the hot and cold supply lines to the stops
with 3/8” compression fittings (included).
Use two wrenches, as shown, to prevent the supply
hoses from twisting.
Place the faucet and sealing washer on the mount-
ing surface.
If the mounting surface is less than 1 3/8”, install
the plastic washer, fiber washer, friction washer,
and mounting nut.
If the mounting surface is greater than 1 3/8”,
omit the plastic washer.
Tighten the mounting nut. Tighten the tensioning
screws.
English
Do not allow either hose to twist.
Twisting the supply hose may cause
it to loosen from the faucet, which
may cause water damage.
For proper operation of the faucet, the hot supply
should be on the left, and the cold supply should
be on the right.
Turn on the water and check all connections for
leaks.