4
5
Install the pop-up drain
• Remove the plunger assembly.
• Unscrew the drain outlet flange from the tee.
• Unscrew the tailpiece from the tee. Wrap
the threads with plumbers’ thread tape and
replace.
• Install the white, flexible sealing gasket to the
flange. Sit it in the sink outlet.
• From under the sink, install the black mack
gasket, white friction ring , and retainer nut to
the flange. Do not tighten the nut against the
bottom of the sink at this time.
• Thread the tee and tailpiece to the flange. The
pivot must face the faucet. If necessary, turn the
drain assembly.
• Tighten the retainer nut.
• Sit the plunger assembly in the drain.
• Install the horizontal rod so that the end goes
through the loop in the bottom of the height
adjuster.
• Install and hand tighten the pivot ball nut.
• Attach the swivel connector to the end of the
horizontal rod.
• Attach the swivel connector to the end of the
vertical rod. Position as desired, and tighten
with a small, flathead screwdriver.
plunger
plunger assembly
height adjuster
drain outlet flange
sealing gasket
mack gasket
friction ring
retainer nut
tee
pivot ball nut
horizontal rod
swivel connector