Filter
Top Products
4
Using the Interaktiv Wallbar
• To remove hand shower from holder, pull up on hand
shower until hose end clears holder, then pull out.
• To change angle of hand shower holder, make sure hand
shower is seated firmly in holder. Grasp top of hand
shower. Using it as a lever, pull or push to desired angle.
• Wrap the threads on the end of the shower arm with several layers of thread
tape. Screw backflow
preventer to shower arm.
Wrap threads on backflow
preventer (if using - not
included) with thread tape.
Remove protective plastic
cap from long hose end
connector to expose the
two black rubber washers.
Place a black rubber
washer in short hose end
connector. Screw it firmly
to backflow preventer.
• Place the second black
rubber washer in the long
hose end connector.
Screw hand shower into hose, taking care not to cross thread. Tighten hand
tight only - using a wrench may damage decorative finish on hose end.
• Feed hose through hand shower holder. Lower hand shower until hose end is
seated firmly in holder.
• Install soap dish.
• Turn on the water and check all connections for leaks.