Filter
Top Products
3
Showerhead Installation
Remove the old showerhead:
While holding the shower arm, remove the exist-
ing showerhead by turning counter-clockwise with a
wrench.
Clean the threads on the shower arm with a wire
brush.
Install the new showerhead:
Slide the boot onto the shower arm. Push it out of the
way.
Screw the showerhead onto the arm by hand. Finish
tightening with a wrench, if desired.
Turn on the water and check for leaks.
Pull the boot down over the joint.
Note: Retroaktiv 06397XX0 does not include a boot.
Handshower Installation
Place the screen washer in the end of the handshower
hose (not included). Screw the hose to the hand-
shower.