Filter
Top Products
Hampton
®
H25-1 Direct Vent Freestanding Gas Stove
39
To Remove Fan:
1) Unplug or disconnect power source to
stove.
2) Remove the rear access panel on the back
of the stove by removing the 2 screws under
the rear panel, then lift off the 2 screws at
the top. Take care not to cut wires when
lowering the panel.
FAN MAINTENANCE
If your fan requires maintenance or replace-
ment, access to the fan is through the rear
access panel on the back of the unit. NOTE:
the unit MUST NOT be operated without
the fan access panel securely in place and
correctly sealed.
IMPORTANT: These fans collect a lot of
dust from within your home. Ensure you
maintain these fan motors on a regular basis
by vacuuming out the fan squirrel cages,
around the motor, and around the grills on
the back of the stove.
IMPORTANT
Disconnect power supply
before servicing
GENERAL VENT
MAINTENANCE
Conduct an inspection of the venting system
semi-annually. Recommended areas to inspect
as follows:
1) Check the Venting System for corrosion in
areas that are exposed to the elements.
These will appear as rust spots or streaks,
and in extreme cases, holes. These com-
ponents should be replaced immediately.
2) Remove the Cap, and shine a fl ashlight
down the Vent. Remove any bird nests, or
other foreign material.
3) Check for evidences of excessive condensa-
tion, such as water droplets forming in the
inner liner, and subsequently dripping out the
joints, Continuous condensation can cause
corrosion of caps, pipe, and fi ttings. It may
be caused by having excessive lateral runs,
too many elbows, and exterior portions of the
system being exposed to cold weather.
4) Inspect joints, to verify that no pipe sections
or fi ttings have been disturbed, and conse-
quently loosened. Also check mechanical
supports such as Wall Straps, or plumbers'
tape for rigidity.
5) Verify proper operation after servicing.
LOG REPLACEMENT
The unit should never be used with broken logs.
Turn off the gas valve and allow the unit to cool
before opening door to carefully remove the
logs. The pilot light generates enough heat to
burn someone. If for any reason a log should
need replacement, you must use the proper
replacement log. The position of these logs
must be as shown in the diagram under Log
Installation.
Note: Improper positioning of logs may
create carbon build-up and will alter
the unit’s performance which is not
covered under warranty.
GLASS
REPLACEMENT
Your sove is supplied with high temperature, 5
mm Neoceram ceramic glass that will withstand
the highest heat that your unit will produce. In
the event that you break your glass by impact,
purchase your replacement door from an au-
thorized Hampton
®
dealer only, and follow our
step-by-step instructions for replacement.
1) Lift off the Cast Top.
WARNING:
Electrical Grounding Instructions
This appliance is equipped with
a three pronged (grounding) plug
for your protection against shock
hazard and should be plugged
directly into a properly grounded
three-prong receptacle. Do not cut
or remove the grounding prong
from this plug.
MAINTENANCE
2) Open the 2 latches of the Glass Front.
Latches
3) Lift the Glass Front Assembly up.
4) Remove the glass and replace with the new
glass.
5) Replace the door and Cast Top.
Replacement Part # 946-327 Glass
WARNING: Do not operate appli-
ance with glass panel removed,
cracked or broken. Replacement
of the glass should be done by a
licensed or qualifi ed service per-
son.
Note: Wearing gloves will protect your
hands while handling glass.
screw screw
Lift Rear Panel off the 2 top screws
screw