Filter
Top Products
4
Using the Allergen Reducer
1. Before First Use: Be sure to remove
all packing materials.
2. See “Replacing the Filter” for disas-
sembly instructions.
Selecting the Proper Location
To prevent the risk of personal injury or damage to the Allergen Reducer and
provide the best possible performance of your Allergen Reducer, follow the
placement guidelines below:
DO NOT:
• Do not stand, sit, or place any objects
on the
Allergen
Reducer. It is
not designed
to support
additional
weight.
• Do not block air intake and outlet
grilles with drapes, curtains, or blinds.
This may cause reduced performance.
• Do not use in cooking areas, garage,
or areas with grease, oil or chemicals
such as solvents or insecticides.
• Do not place on or near heat sources
such as stoves, radiators, or heaters.
• To reduce electrical noise and
interference, do not place on or near,
or plug into the same outlet as TVs,
baby monitors, or cordless phones.
• Do not place in direct sunlight as the
plastic may discolor after prolonged
exposure.
DO:
• Place the Allergen Reducer on a
flat, stable
surface.
• Place Allergen Reducer near an elec-
trical outlet where it is out of the way.
Make sure that the Allergen Reducer
and the cord do not present tripping
hazards.
• Select a central location with adequate
air circulation.
• Turn off and unplug Allergen Reducer
before moving or servicing it, or if it
will not be used for several days.
• Route the electrical cord clear of
furniture to prevent damage from
pinching the cord.
Replacing the Filter
How to Assemble and Use (cont.)
1. Turn off the Allergen Reducer and
unplug from outlet.
2. To remove intake grille, press on the
grille release buttons on each side of
the grille and pull outward from the
top of the grille.
3. Remove the used filter by gripping
the sides and pulling outward.
Discard the used filter. It cannot be
cleaned.
4. Remove any packing materials from
the new filter and install with the air-
flow arrow printed on the filter frame
pointing into the appliance.
840123100 ENv01 3/5/04 9:53 AM Page 4