Filter
Top Products
FRESH Operation
Exhaust the vitiated air from the room, and inhale fresh air.
(This function is unavailable on some models.)
Emergency operation and test operation
Pi
Pi Pi
displayed on the remote controller and
and the change-for-fresh-air function
For twice press , the display " "
disappears and the change-for-fresh-
air function operation is canceled.
Note
If the unit didn’t install change-for-fresh-air electrical
engine, change-for-fresh-air function is not available.
After the change-for-fresh-air function is initiated,
the outside air can enter the indoors through the
change-fresh-air tube thereby keeping the indoor
About change-for-fresh-air function
Setting the change-for-fresh-air function under
the shutdown status, press the fresh air key and
the remote controller displays the on status of air
flow, low wind,and change-for-fresh-air functions,
and now can set the timing open, timing close
The dual fresh air has a memory function, which
can be cancelled by pressing the key one time.
Under the smart mode, after the machine has
Operation
“ ” is displayed on the display board,
been running for a while,the dual fresh air
function will be started automatically,it will be
automatically stopped after continuously running
Emergency Operation:
the room
temperature is below 16 C, do
o
Test operation:
Use this switch in the test operation when
It is not possible to operate in dry mode.
Room
temperature
Operation
mode
Designated
temperature
Timer
mode
Air flow
ABOVE 23
O
C
BELOW 23
C
COOLING
HEAT
23
O
C
26
O
C
NO
NO
AUTOMATIC
AUTOMATIC
(cooling only uint)
Room
Operation
mode
Designated
temperature
Timer
mode
Air flow
BELOW 23
O
C
FAN
26
O
C
NO
AUTOMATIC
Test operation switch is the same as
Use this operation only when the remote
controller is defective or lost.
When the emergency operation switch
is pressed,the"Pi" sound is heard once,
In this operation,the system automatically selects the
operation modes,cooling tor fan or heat, according to
Continue to press the test operation switch for more than
5 seconds. After you hear the
"Pi" sound twice,release
your finger from the switch:the cooling
operation starts
O
Air Filter cleaning
Clean the filter
Attach the filter
Close the inlet grille
Once every
two weeks
Open the inlet grille by pulling
Remove the filter
Push up the filter’s center tab slightly until it is
released from the stopper, and remove the filter
Use a vacuum cleaner to remove dust, or wash
the filter with water. After washing, dry the filter
For smart Use of The Air Conditioner
AM
SMART
Press FRESH button “ ” is
operation begins.
and time control switch.
air fresh.
for a while.
temperature
which means the start of this operation.
the room temperature.
emergency switch.
not use it in the normal operation.
with the air flow speed
"Hi".
downward.
completely in the shade.
it upward
Attach the filter correctly so that the
“FRONT” indication is facing to the
completely fixed behind the stopper.
If the right and left filters are not
front. Make sure that the filter is
attached correctly, that may cause defects.
10