Filter
Top Products
Installation
Power Cord Installation
1. Disconnect power to the PTAC
unit.
2. Remove the plastic front cover.
3. Remove the power cord cover.
See Figure 1.
4. Install the power cord into the
connector on the PTAC unit until
the top and bottom tabs engage.
See Figure 2.
Figure 1. Power cord cover
Figure 2. Connector installation
Tabs
5. Remove the power cord strain
relief, and wrap it around the
power cord. Reconnect the
strain relief to the PTAC unit.
See Figure 3.
6. Reinstall the power cord cover.
See Figure 4.
7. Reinstall the plastic front cover
on to the PTAC unit.
Figure 3. Strain relief
Figure 4. Power cord cover
Strain
Relief