Filter
Top Products
Don't spray any paint or insecticide on the unit.Don't splash water directly on indoor unit.
This will cause damage or even fire accident.
This could be
very dangerous
Disconnect power supply Don't touch it with wet hand Don't wash with hot water or solvent to
clean the unit
10
Maintenance
Pull it out from top as shown in Fig.
Wash it with clean water and install it after complete dry.
Air filter cleaning
Use water or vacuum cleaner to clean it. If it is extremely dirty,
wash it with neutral detergent or soap water.
Don't use hot water over 40 C, as this may cause damage to air filter.
Wipe air filter carefully.
Caution:
After season maintenance
Before season maintenance
Let the unit run in Fan mode for half a day in a fine weather to dry completely the unit inside.
Turn off the unit and pull out power plug. Otherwise, there might be certain power consumption
even if the unit is stopped.
Clean air filter and indoor unit, cover outdoor unit after cleaning.
Check if there are obstacles at inlet and outlet of indoor and outdoor unit, whick will reduce unit
efficiency.
Don't fail to attach air filter after making sure it is cleaned. Dust will enter into unit causing
damages or faults if it is running without air filter.
To protect compressor at start, please connect external power supply to the unit 12 hrs prior to
starting. Also please keep the power supply switch ON during the whole season.
Clean it with warm and wet cloth or with neutral detergent, then wipe it dry with clean and soft cloth.
If air conditioner is very dirty, clean it with cloth soaked in neutral detergent, then wipe off the detergent with clean water.
Don't use water higher than 40 C, which will cause discoloring and deformation.
Don't use insecticide or other chemical detergents.
Indoor and outdoor cleaning