Filter
Top Products
2
AUTO COOLING DEHUMIDIFYING HEATING FAN
AUTO
LOW FAN MED FAN HIGH FAN AUTO
SET
ON/OFF
MODE
FAN SWING
TEMP
CLOCK
SET
TIMER
SLEEP
RESET
FILTER RESET
7
Operation instruction
Auto/Cooling/Dehumidifying/Heating operation
Hints:
The wire controller can memorize the working condition of each time. When
start the unit for the second time, just need to press ON/OFF button, the air
conditioner will work according to the previous working mode. (except for
Timer, Sleep and Swing)
Turn on the unit
Press the ON/OFF button to turn on the
unit The LCD display of the wire
controller will show the previous working
state (except for TIMER, SWING, SLEEP
mode). The operation indicator light on
the wire controller will light up.
3
1
Choose of working mode
Press MODE button, each press the
working mode will change as the
following sequence:
then choose AUTO, COOLING,
DEHUMIDIFYING, HEATING operation.
Set temperature
*Each press , the set temperature will
increase 1 degree.
*Each press, the set temperature will
decrease 1 degree.
Set the desired temperature.
Press the TEMP. SET button
Adjusting FAN SPEED
Press the FAN SPEED button, for each
press, the fan speed will change as the
following sequence:
Choose the desired fan speed.
In Heating operation, after start
the unit, the air conditioner will
sending warm air a moment later
to prevent the cold air blowing
out. In Dehumidifying, when the
room temperature drops 2*
higher than the set temperature,
regardless the set fan speed, the
air conditioner will intermittently
operate in low fan speed.
4
5
1
4
3
2
3
5
Turn off the unit
Press the ON/OFF button to turn off
the unit.
The wire controller only shows the clock
and room temperature.
About AUTO operation:
In AUTO operation, the air conditioner will operate and automatically choose COOLING,
HEATING or FAN operation according to room temperature.
Set temperature + 2*
Set temperature
When room temperature
reaches set temperature
+ 2*, the unit will
operate in mild
dehumidifying operation.
Ultra-low air flow
When room temperature
is higher than set
temperature, unit in
COOLING operation.