Filter
Top Products
7.
INSTALLING THE DECORATED BOARD ON THE BODY OF INDOOR UNIT
6
7
21
4
2
2
1
3
As shown in Fig. 1, make the wind deflector motor of the decorated board face to the orifice of the indoor
unit, and then mount the decorated board onto the body of the indoor unit.
Mounting the decorated board:
a. Hang temporarily the swing rings(2 pcs) opposite to the deflector motor of the decorated board on the ring
stators of the swing rings of the indoor unit;
b. Hang temporarily the other swing rings on the ring stators of the swing rings of the indoor unit (take care
not to get the lead wire of the deflector motor into the sealing);
c. Screw all 4 hex head screws under the rings about 15mm to lift the board;
d. Turn and adjust the decorated board in the direction of arrow as shown in Fig. 4 until it covers the hole of
the ceiling.
e. Fasten the screw to keep the thickness of the sealing between the decorated board and the unit body within
5-8mm, as shown in Fig. 2.
f. Mount the wiring of the decorated board according to the mounting drawing attached tothe inside of the
machine;
g. Check with the control if the mounting is correct and make sure if the machine work snormally;
h. Mount the air inlet grid and angle covers.
Fig.1
5-8mm
indoor unit
ceiling material
sealing
decorated board
Fig.2
swing ring
orifice location
deflector motor
Installation Procedures