Home Automation RC-80 Thermostat User Manual


 
Repeat steps 1-6 for the
DAY
,
EVE
, and
NITE
periods. Afterwards,
repeat steps 1-6 for 4 daily periods on Saturdays (Day 6), and 4
daily periods on Sundays (Day 7). The temperature display will
show "6" for Saturdays, and "7" for Sunday times.
Note: If Programming Mode is not being used and Day/Night Mode
is being used, only the Weekday - DAY and NITE settings can
be programmed.
DAY/NIGHT MODE
Your thermostat can be configured to change its temperature settings
from "DAY" to "NITE"
when commanded from a remote location.
If so, the thermostat will use the weekday "DAY" and the weekday
"NITE" settings.
"REMOTE" and either "DAY" or "NITE" will be displayed when a
command is sent from a remote location. You can use the arrow keys
(-) to override the temperature settings, or press the Hold key to
prevent any future remote changes.
Follow the procedure shown in Programming Mode, to change the
programmed DAY and NITE settings.
PROGRAMMABLE ENERGY SAVER MODE
(PESM)
Your thermostat can be configured to allow a remote system to
override it. The thermostat sends the temperature to the remote
system. The remote system will use the temperature to determine
whether or not to override the thermostat based on its own
temperature settings.
"REMOTE" will be displayed when the remote system has control of
the thermostat. You cannot use the arrow keys (-) or any other key
on the thermostat to override the remote system. To resume normal
operation of your thermostat, you must turn the energy saver feature
off at the remote system.
11