Filter
Top Products
– 11 –
OPERATION
AUTO TURN-ON / SLEEP MODE
The TRM10s/TRM12s subwoofers automatically turn on when they sense an input signal. When the signal being fed to the
TRM10s/TRM12s is turned off, the subwoofer's amplifier will turn off and go into "sleep mode." This feature eliminates the
inconvenience of operating a mechanical switch.
INPUT SENSITIVITY
The Input Sensitivity is used to match the TRM10s/TRM12s with signal levels from a variety of mixing consoles. The Input
Sensitivity uses a potentiometer to match input levels over a 30dB range and is variable from +1dBu to -30dBu. The numbers listed
on the back panel indicate the input in dBu required to produce an output of 100dB SPL @ 1 meter. When the control is set to
its full CLOCKWISE position the monitor is matched to +1dB input level (the input circuit is less sensitive to the amplitude of the
input signal). When the control is set to its full COUNTER CLOCKWISE position the monitor is matched to -30dB input level (the
input circuit is more sensitive to the amplitude of the input signal).
LOW-PASS CROSSOVER
The Low-Pass Crossover is used to set the electrical cutoff point
of the subwoofer enclosure. The Crossover uses a variable
potentiometer to set the cutoff point anywhere between 40Hz
and 140Hz. When the control is set to its full CLOCKWISE
position the cutoff frequency is set to 140Hz Low-Pass. When
the control is set to its full COUNTER CLOCKWISE position the
cutoff frequency is set to 40Hz Low-Pass.
It is important to match the Low-Pass crossover point of the
subwoofer with the High-Pass crossover point of the high
frequency reference monitors. Mismatching the crossover
points can cause dips or peaks in the acoustical response.
Overlapping the crossover points (i.e., subwoofer at 60Hz
Low-Pass & high frequency monitors at 50Hz High-Pass) will
cause a peak between 50Hz and 60Hz. Underlapping the
crossover points (i.e., subwoofer at 40Hz Low-Pass & high
frequency monitors at 70Hz High-Pass) will cause a dip
between 40Hz and 70Hz.
*This graph was generated by setting the variable crossover to
40Hz, 50Hz, 60Hz, 70Hz, 80Hz, 90Hz, 100Hz, 120Hz & 140Hz.
50
60
70
80
90
100
120
140
40HZ
Low Pass
50
60
70
80
90
100
120
140
40HZ
Low Pass
Electrical Crossover Response*