Haan SI-70 Vacuum Cleaner User Manual


 
9
IMPORTANT: Vibration Sound
IMPORTANT
While the unit is turned off, air builds up in the water pump
line. This is a common occurrence. When the unit is turned on
the water pump pushes air out of the line and emits a vibrating
sound. This occurs while the unit is heating up and also when
the water tank is emptied during use. If the vibration sound
persists for more than 60 seconds during heat up, check to make
sure the water tank is assembled correctly.
Always empty the water tank once you have finished using your
Floor Sanitizer.
TAB
TAB
“Hands Free”
Removal Tab
7
1 2
10
Tilt handle at a 45º angle. Push
and pull slowly across the floor
to clean thoroughly.
Attach carpet glide by placing
unit under “tabs” and gently
pushing down into place.
With carpet glide attached, place
on Floor Protector / Resting Mat.
Turn unit ON and follow operat-
ing instructions to clean.
Turn unit OFF, let cool. Use
foot on “Hands Free” tab to
remove Tray from steam head.
When unit has cooled, remove
Ultra-microfiber pad. Store
unit upright in a dry area.
8
When done, push ON/OFF button.
9
Place unit with Ultra-microfi-
ber pad attached onto Floor
Protector / Resting Mat. Allow
to cool down for five (5) min.
Using the Carpet Glide
What is the Carpet Glide?
The carpet glide enables the Floor Sanitizer to freshen, deodorize and sanitize carpet-
ing, rugs, upholstery, pet cushions and more. Used with the Floor Sanitizer it kills dust
mites and other allergens on a variety of surfaces.
NOTE: The Carpet Glide is used WITHOUT the Ultra-Microfiber Pad.
3
To Remove
Carpet Glide